ACS & multiple Active directory
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2015 03:04 AM - edited 03-10-2019 10:44 PM
Does ACS support multiple active directory integration
Regards
Nikhil
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2015 05:29 AM
I see there is an option to add only one domain name & can use mutual trust domains . Are there any limitations in using this.
Can I use any number of groups in the second domain as well.
How a user will be authenticated, when an incoming authentication request comes to the ACS. Does ACS check with first ACS, and fallback to the second ACS, if the user is not seen in the first ACS
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-21-2015 11:13 PM
I have one ACS and wants to integrate with 3 AD. is it possible in ACS 5.6?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2015 08:28 AM
ACS can be integrated with multiple AD, only if the AD have mutual trust between each other..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-22-2015 09:51 AM
Yes you can! However, one integration would have to be done via the AD connector and the other via the LDAP one.
With that being said, Cisco ISE, does have the option to fully join several domains. Have you explored that product?
Thank you for rating helpful posts!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2015 08:29 AM
I have tried with ISE, it is good.
Thanks for the suggestion. However I found that all the AD should have same time synchronized. This was making my configuration complicated
Regards
Nikhil
