Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
444
Views
0
Helpful
1
Replies

ACS Replication

Terry
Level 1
Level 1

‎03-24-2010 03:28 AM - edited ‎03-10-2019 05:01 PM

Hi,

I currently trying to set up replication between two ACS servers (installed on windows) both running software version 4.2.1.15.

The replication completes ok (as shown in the logs on both servers), but the replicated config is not showing on the secondary server.

So for example - I have 'Network Configuration Device Tables' checked on both servers (send on primary / receive on secondary), but these configured devices do no show under 'Network Configuration' when the replication has completed.

Has anyone seen this issue before? or is there something I am missing here?

Kind Regards

Terry

Labels:
0 Helpful
1 Reply 1

Javier Henderson
Level 4
Level 4

‎03-24-2010 12:05 PM

Set the log level detail to full (System Configuration -> Service Control) and restart the services, then replicate again, and then look at the log files in the ACS services directories, in particular CSAuth.

0 Helpful
Customers Also Viewed These Support Documents