ACS upgrade?

[paltel]

I have ACS ver 3.0 and i want to configure a redundant ACS server, the problem is, i need to install new ACS ver 3.0 to the redundant server because if i install acs ver 3.3 i can't restore the data from the old ACS ver 3.0 to the redundant one with ver 3.3.... any help or other solution?

Thanks

[dan.reynolds]

I just went through something similar to what you are talking about. What I did was to upgrade the 3.0 server to 3.1.4. 3.1.4. is an upgrade path to 3.3.1.

The upgrade process took about 15 minutes with out any problems. I think that you can have TAC post 3.1.4 so you can get it downloaded.

[paltel]

Hi Dan,

Thanks for you reply, i don't like to put my authentication server at risk, i search for ACS ver 3.0 to download and i did not find it, i want it to install on the redundant server and backup the data from the old one and restore it on the redundant and after that i will upgrade the redundant one and if it's o.k i will use this as primary and the old one as redundant.

Thanks alot

[paltel]

Any Comments?

[dan.reynolds]

Sorry it took me so long to respond to your post, I was on vacation for the last 2.5 weeks. I got a copy of 3.0 from the TAC. I had to open a case and then they uploaded it to the site and then sent me a link to the upload it took them a day or so to get it uploaded because of the age of the software.

[paltel]

Hi Dan,

Thanks alot for your help, i hope to get this software ASAP,thanks again. They will give you the link to download this ACS v3.0 software, and you can tell the link or what?

Anyway, my email address is

abd.hamad@paltel.net

THanks again

Abd Alqader

[dan.reynolds]

yes they will send you an email that has the link in it. I sent you an email with more info. I hope that it helps!

[Naveen Kumar]

Just to share ACS 5.5 - Upgrade procedure:

https://supportforums.cisco.com/docs/DOC-40591