Automatic Compliance when network switchover

[nikhilcherian]

I see the in the Anyconnect Admin Guide (Cisco AnyConnect Secure Mobility Client Administrator Guide, Release 4.1  - Configure Posture [Cisco AnyConnect Secure …) the below line

================

In the ISE UI (in Settings > Posture > General Settings), you can specify an amount of time when an endpoint is considered posture compliant after an initial compliance check. The compliance status is expected to be preserved even when users switch from one communicating interface to another.

================

Which will help the client not to undergo any posture check if switching between network

In my ISE 2.0, I can an option for " Posture Lease " which asks to check the Posture everytime the client connect to the network or specify the minimum number of days. Is the minimum time 1 day, can I have less time than this

Regards

Nikhil

[Jason Kunst · Accepted solution]

Lowest is 1 day

http://www.cisco.com/c/en/us/td/docs/security/ise/2-0/admin_guide/b_ise_admin_guide_20/b_ise_admin_guide_20_chapter_011010.html?bookSearch=true

[nikhilcherian]

Thanks Jason