04-13-2020 03:15 AM - edited 04-13-2020 03:19 AM
Dear all. i have created lab envirement on eve-ng and trying to learn cisco ise. i configured switch as below
aaa new-model
!
!
aaa group server radius ISE
server name ISE01
ip radius source-interface Vlan1
!
aaa authentication dot1x default group ISE
aaa authorization network default group ISE
aaa accounting update newinfo periodic 2880
!
interface vlan 1
ip address 10.10.10.100 255.255.255.0
!
radius server ISE01
address ipv4 10.10.10.20 auth-port 1812 acct-port 1813
key cisco
!
Then tested using command shown below. But unfortunatelly nothing shown on Radius Live logs. i choose network device as default and enabled it with Radius key. Could you please instruct me to configure switch that cause logs not to be shown on radius live logs?
Switch#test aaa group radius test-user test-password new-code
User rejected
Solved! Go to Solution.
04-16-2020 07:21 AM
04-16-2020 07:29 AM
That is the one i have installed. If i increased ram to 16 gb dont you think other virtual machines would work slowly? I have computer with 16 gb ram. i use windows 7, windows server CA, and Cisco ISE. do you think by increasing ISE's ram wouldnt affect other machines rapidity?
04-16-2020 08:44 AM
04-16-2020 09:21 AM
thanks poongard. i wiil install and test it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide