CiscoSecure ACS 2.6 and command line import utility

[a.aitken]

I can import users via csutil.exe but is it possible to set a static IP address using csutil? Basically I set up users in batches and some need static IP's so it would be easier doing it all at once. Alternatively could someone suggest an ASP/VBScript based solution for importing users/passwords/groups and setting IP addresses if the user belongs to a specific group?

Any useful help would be much appriciated !!

Regards

Adrian

[yusuff]

It is not possible to set a static IP address using csutil, only options available are listed in Table E-1 in the following URL

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/csnt30/user/ae.htm#xtocid1602210

R/Yusuf

[a.aitken]

Thanks, I was hoping to do it without ODBC but it looks like thats how I'll have to do it.

Regards

Adrian