Configure Cisco ISE Closed-mode on Huawei switch

[oum-odom]

Dear Cisco ISE lover, 

I would like to seek your sharing experience on Cisco ISE for Closed-mode. 
While we have another switch (Huawei) does it support for this closed-mode? 

Thank you, 

[Karsten Iwen]

I don't know the Huawei switches, but closed-mode is the default operation of 802.1X. If the switch supports 802.1X, closed-mode will be available. The question would be if there are the other Cisco IBNS modes like monitor or low-impact available.

[oum-odom]

Yes, thank for your answer.

[MHM Cisco World]

ISE don't care about modes of SW

What important to ISE is it will push dACL or VLAN ?

dACL for low cost mode or monitor mode of SW 

VLAN for close mode 

MHM

[oum-odom]

While we used dACL for closed mode on Cisco Switch. 

So, what about Huawei switch does it support closed mode or profiling?

I would seek for real user experience on top of document.

[MHM Cisco World]

https://support.huawei.com/enterprise/en/doc/EDOC1000114001/6cb5f9af/delivering-vlans-or-acls-to-successfully-authenticated-users-on-cisco-ise#section661418153110

It close mode with dACL not common' but anyway check link above 

MHM