Configure ISE policy node remotely

[#1]

2 new Cisco ISE policy nodes are sent to 2 oversea offices directly.  Is it possible to configure it remotely from a console port of ISE or I have to relay on local techs to do the initial configuration?

Thanks,

[Tim Steele]

Eric,

I assume these are either 3415 or 3495 appliances.  I would recommend setting up the CIMC out of band management interface.  This will allow you to launch a virtual KVM which you can use to step through the setup wizard as well as reimage remotely if that is ever needed.  You'll need someone on site to attach a physical KVM to the appliance in order to do this.  Take a look at this link:

http://www.cisco.com/c/en/us/td/docs/security/ise/1-4/installation_guide/b_ise_InstallationGuide14/b_ise_InstallationGuide14_chapter_011.html#ID-1415-00000063

Tim