Configuring PIX as a Blocking Device

[admin_2]

Hi!

I have IDS sensors configured to use PIXs as blocking devices. Could anyone tell me how I can configure the firewalls to let the IDS sensors modify their access lists.

I'd appreciate if you would point me to any good documentation about the subject.

Regards,

Bercy

[mhoda]

Hello Bercy,

Not sure what managment software are you using, but this doc is helpful to understand the concept -

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080145270.shtml#table2

I hope this helps. Regards,

Mynul