I search CCO on setting the supplicant version for a Cisco AP1600, but so far I could not find anything about it.
So my question is; If it is possible the set the 802.1x supplicant version on a AP1600 from version3 (default) to version 1 because the other-vendor switch only supports EAPOL version 1.
Please go through the guide for Configuring Authentication for Access Points:
Thanks for the reply, but the mentioned document did not show if it possible, or how to set the EAPoL supplicant version for the AP 1600.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: