EAP-TTLS authentication on RADIUS server

[AndBogorev]

I have a WLAN based on CISCO Aeronet equipments and WinXP station. I need to implement EAP-TTLS authentication, but ACS does not support this protocol. I have determined to implement other(no CISCO) RADIUS server, that is located in another country.

Question: What are the commands necessary for installing AP for working with remote RADIUS server?

Thanks for your helping.

BR,

Andrew

[vkapoor5]

As far as I know, the only configuration on the AP is to supply the IP address of the RADIUS server. As long as the AP can reach the RADIUS server, you should be fine.

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801bd035.shtml#NetEAP

There is also an option to configure a local RADIUS server on the AP itself, that can support a small number of users.

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801c0912.shtml