How can see Log more than 30 day In Cisco ISE 2.4

[jewfcb001]

Hi Everyone . 

I would like to know How can i see log in Cisco ISE more than 30 days ? 

ISE Version

Version : 2.4.0.357

Please see picture attached

[Arne Bier · Accepted solution]

Hi @jewfcb001 

You need to use the Operations -> Reports menu option.

The key thing is that you need to click on the filter and choose Advanced

And then choose the custom date range

[jewfcb001]

@Arne

Thank you for your information.

[Damien Miller · Accepted solution]

Adding to Arne's date ranges, and assuming you were not already aware, ISE only maintains up to 30 days by default. You would have to adjust the data retention period as well.  From that point on, ISE will attempt to maintain the number of days specified, but if space runs low, it will begin to aggressively clean up. So adjust with caution. 

[jewfcb001]

@Damien
Thank you for additional information . I have a small question . Data Purge will retention auto or not ? If disk space runs low .

[Damien Miller]

It will begin to auto purge when it hits the 80% mark if I remember correctly. But it's best to monitor it if you are adjusting the data retention period and keep it below that.