How do I use an Access policy other than Default Device Admin? In ACS 5.3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-08-2015 11:15 AM - edited 03-10-2019 10:43 PM
I am trying to test an access policy in ACS 5.3, but I am unable to find how to use the new policy with a specific switch. This is a live system and I cannot modify the "default device admin" policy until the new one is tested.
I suspect it is a configuration in the switch, but what I tried did not work.
TIA
- Labels:
-
AAA

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-11-2015 03:50 AM
Try to take a test device for you to test your new policy. add that device in your NDG(aaa client) and see how it goes.
hth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2015 11:05 AM
Thanks for your help.
I had to restart the ACS service. Apparently, some of the changes were made with Google Chrome.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-11-2015 09:54 AM
I found how to do this "service selection rules" but even when my rule is on top, it is ignored.
ceracaza08, unfortunately, I do not have a test device available.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-12-2015 08:07 AM
Are you using Internal identity or External Identity Stores? Can you provide the condition of your Service Selection Policy and Access service Policy?
