How to get ACS3.2 to assign different attributes for multiples NAS's

[crazycrok]

We are running ACS3.2 and have 3 different types of NAS for each group of users (two managed dial solutions and 1 home grown VPN concentrator solution).

The problem is that the two dialup NAS's require different RADIUS attributes for the IP address assignment: one NAS uses a named pool, the other NAS assigns the pool based on an IP entry in attribute 8 (framed IP address). Users mapped to one ACS group must be able to use both dial services.

Is it possible to configure ACS so that one type of attribute is used for one NAS and another type of attribute for the other for users belonging to the same group?

Thanks,

Matt

[nikhil_m]

No Matt, this is not practically possible

[crazycrok]

Hmm, I thought you might say that:(

I've done a bit of jiggery pokery and will be doing some testing tomorrow.

I'll post back to this forum to let you know how it goes.

Matt