11-29-2017 02:26 AM - edited 02-21-2020 10:40 AM
Hi All
I found the acl not work before my device during running auth
below is the ACL
interface command
AAA command
Would you have any suggest for me?
Thanks!
11-29-2017 03:49 AM
Depending on the switch and version a "show ip access-list interface gig1/0/5" could shouw you the actually applied ACL. Looking at the config is not a valid check here.
And have you tried if there is really something different in place? Based on the shown output I would assume it works as expected.
11-29-2017 07:21 AM
Thank for your reply!
when the interface running auth to show ip access-list interface gig1/0/5.
I can't found any ACL is running.
on then other hand, when auth is work, it can successful the download ISE's DaCL to interface and work.
Would you have any suggest to ip access-group was failed?
Thank for your help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide