ip access-group not work between running Ath

[billywaiclassmate]

Hi All

I found the acl not work before my device during running auth

below is the ACL

interface command

AAA command

Would you have any suggest for me?

Thanks!

[Karsten Iwen]

Depending on the switch and version a "show ip access-list interface gig1/0/5" could shouw you the actually applied ACL. Looking at the config is not a valid check here.

And have you tried if there is really something different in place? Based on the shown output I would assume it works as expected.

[billywaiclassmate]

Thank for your reply!

when the interface running auth to show ip access-list interface gig1/0/5.

I can't found any ACL is running.

on then other hand, when auth is work, it can successful the download ISE's DaCL  to interface and work.

Would you have any suggest to ip access-group was failed?

Thank for your help