- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2014 09:18 PM - edited 03-10-2019 10:14 PM
Hi,
Hopefully, this is an easy question and I am just not looking in the right place.
Is there somewhere on ACS v5.x where I can view a history of all the commands that were executed on the ACS CLI ?
This is where I have looked:
- I have looked through the reports in ACS View under:
Monitoring & Reports > Reports > Catalog > ACS Instance
Although some of these reports show CLI actions I cannot see a report that shows the actual commands that were entered. - I have also checked the logs in CLI under "show logging system log_filename"
- I have also run a support bindle and checked the files there as well.
Any advice would be appreciated.
Solved! Go to Solution.
- Labels:
-
AAA
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2014 10:01 AM
Can you please try checking ADE.log log file. You may not able to view the command directly but you will be seeing the logs with some numeric format as follows:
operation: 0
operation:1
For example the complete log looks like :
ADE-SERVICE[4749]: [30538]:[info] application:operation cars_install.c[1892] [admin]: Application initialization initiated for appname: xxx, operation: 0
I don't think so we will have the track on all the complete list of commands that were executed on CLI. From logs we can figure out what are the commands executed.
Thanks,
Naresh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2014 10:01 AM
Can you please try checking ADE.log log file. You may not able to view the command directly but you will be seeing the logs with some numeric format as follows:
operation: 0
operation:1
For example the complete log looks like :
ADE-SERVICE[4749]: [30538]:[info] application:operation cars_install.c[1892] [admin]: Application initialization initiated for appname: xxx, operation: 0
I don't think so we will have the track on all the complete list of commands that were executed on CLI. From logs we can figure out what are the commands executed.
Thanks,
Naresh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-09-2014 08:37 PM
Thank you Naresh. I was hoping there would be a cli command log that could reviewed but if that's the best there is then I will look at that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-25-2020 02:19 PM - edited 02-25-2020 02:20 PM
Did you ever figure this out? How can you view configuration changes users make on devices(routers and switches) through the ACS GUI?
