ISE 2.2 Patch 10

[albowi]

Is anyone experiencing similar problems upgrading from patch 2.2 patch 5 to Patch 10 ?

I have a environment running ISE 2.2 patch 5

running on 2 adm nodes 2 log nodes and 4 psn's

downloaded ISE 2.2 patch 10 

verified MD5

When upgrading from GUI it started installing on all nodes (exept 1) 

all 7 patched nodes was stuck in - initializing state for 1 hour+

except my one psn that stayed un-patched and active.

- got to the point where my service window ran out.

- supplied TAC with support bundle and log info. so far reply was to try upgrading from CLI in service window.

cleared a service window for tonight -

installed from CLI on the primary node - still got the same result: 

Application Server initializing

show application:

ise Cisco Identity Services Engine
Patches: 2 3 5 10

Is anyone experiencing the same problems ?

[anthonylofreso]

Hmm. Good luck resolving this... sounds like a tough one.

We're running patch 9 still, so I can't speak to patch 10 install. However, there was a post from somebody else last week who also had trouble: https://community.cisco.com/t5/policy-and-access/cisco-ise-2-2-patch-10-breaks-deployment/m-p/3712781#M71431

His symptoms appear to be different though. Keep us posted here on what you figure out with TAC.