ISE Backup error

[pemasirid]

Hi,

Has anyone faced the below issue while doing backup.? I found that it was documented in a bug and shown as fixed but still getting even with patch 2

https://tools.cisco.com/bugsearch/bug/CSCuq63732/?referring_site=bugquickviewclick

Sun May 24 10:42:32 AST 2015: backup isebackup_24052015-CFG-150524-1042.tar.gpg to repository ISE-REPO: failed - Error: The data fil

esystem is 76 percent full, which is above threshold of 70. Backup aborted

Sun May 24 10:58:19 AST 2015: backup isebackup_24052015-CFG-150524-1058.tar.gpg to repository FTP-SERVER: failed - Error: The data f

ilesystem is 76 percent full, which is above threshold of 70. Backup aborted

Sun May 24 12:11:17 AST 2015: backup xxxxisebck-CFG-150524-1211.tar.gpg to repository ISE-REPO: failed - Error: The data filesyste

m is 76 percent full, which is above threshold of 70. Backup aborted

XXXX-XX-ISE1/admin# backup xxx_isebck repository ISE-REPO ise-config encryption-key plain Ise1234567

% Internal CA Store is not included in this backup. It is recommended to export it using "application configure ise" CLI command

% Creating backup with timestamped filename: xxx_isebck-CFG-150524-1238.tar.gpg

% backup in progress: Starting Backup...10% completed

% Error: The data filesystem is 77 percent full, which is above threshold of 70. Exiting the backup

% Application backup error

Appreciate if anyone can advise how we can fix this.

thanks

[Kanwaljeet Singh]

Hi,

Which version of ISE are you running? I would suggest to contact TAC, get the space cleaned up and after that you should be able to take the backup.

Regards,

Kanwal

Note: Please mark answers if they are helpful.

[pemasirid]

Hi Kanwal,

Thanks for your response. I am running ISE 1.3 with patch 2. Is this can be done by ourself or has to do only by TAC.?

Thanks

[Kanwaljeet Singh]

Hi,

I would recommend contacting TAC and do this under their supervision.

Regards,

Kanwal

Note: Please mark answers if they are helpful.