I am trying to setup an ISE deployment to allow me to connect to an SSID for client provisioing only. The provisioing should install a certificate from the CA server and setup the new SSID eap-tls authentication settings. I have two questions in regards to this.
First can I provision a device without going through the device registration process?
Second is that on my iPad I don't ever get to the provisioing piece. It pops up the device registration page and skips right to me installing the Root CA certifcate and then never allows me to actually register the device. On my windows 8 laptop I register the device and it starts provisioing the client but fails while provisioning. Any ideas on what to look for on why that happens?
My ISE nodes all have good certificates and the SCEP CA is setup along with the CAP for my identity source sequence.
At a loss could use some help.
