ISE for certain users

[suthomas1]

Good day all,

We are slowly stepping into using ISE for lan access control. In testing this, is there a way to only test it for few user ports on cisco 3800 switches only? This is so as to only test on few selected user ports so less issues are caused for others. & is there an easy way to take this off - simple port config?

Thanks.

[Mark Elsen · Accepted solution]

 - You can limit dot1x or mab port-configurations to selected ports in a migration traject (e.g.)

 M.

[Mike.Cifelli]

Absolutely.  See here for further details: ISE Secure Wired Access Prescriptive Deployment Guide - Cisco Community