- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-01-2020 05:56 AM
Hi
I need to compare unit attributes captured from the different probes.
If I go to "Context Visibility" -> "Endpoints" -> "Export" I get a database (CSV) that misses most of the various attributes.
Is there a way to extract all the information?
ISE runs 2.7.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2020 04:00 AM
Hi @mini
SSH into your ISE and enter the command 'application configure ise'. There you have the option 'Get all Endpoints'. This creates a CSV with most of the information available.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-01-2020 06:45 AM
Have you tried to go reports > diagnostics > endpoints. See if this
fulfill your requirement.
***** please remember to rate useful
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-02-2020 12:49 PM
If you have access to use it, try the ISE Endpoint Analysis tool by Cisco. Or an endpoint dump from the admin cli might have the attributes you're looking for, application configure ise, option 16.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-02-2020 03:33 PM
The Cisco EAT tool is the ideal candidate for this, I tend to have a lot of problems trying to run it myself. If you can get it to work and it doesn't crash, then it probably has the attributes the OP is after.
Not sure if it is publicly accessible though.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2020 04:00 AM
Hi @mini
SSH into your ISE and enter the command 'application configure ise'. There you have the option 'Get all Endpoints'. This creates a CSV with most of the information available.
