ISE - Inline Posture Node Deployment Issue - User can not access network after pass authentication checking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2014 12:09 AM - edited 03-10-2019 09:51 PM
Hi Experts,
I have recently deployed a ISE iPEP in front of a Aruba WLC in bridge mode. After user pass authentication on Aruba WLC, I can see from Monitoring node that the employee role have been granted to the userand a "permit any any acl" has been pushed to IPN. However, user still can not have any network access. When I issue command :" show pep table accesslist normal" and " show pep table session" on IPN but it show nothing. Did anyone have experience the same issue? or any solution or recommended troubleshooting steps?
Regards,
Eric
- Labels:
-
AAA

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2014 08:45 AM
http://community.arubanetworks.com/t5/Controller-Based-WLANs/Does-Aruba-Controller-support-switching-vlan-using-COA/ta-p/194579
