06-05-2017 04:05 AM
I have an ISE using two interfaces.
I am unable to ping out of the second interface (gig1). There are no packets showing Rx or Tx.
The working interface (gig0) shows a status of "Up, Running and Broadcast" but the second interface (gig1) only shows "Up and Broadcast".
Does anyone know what the "running" state means and how to get the second interface into a running state (if that's what required)?
Regards
John
Solved! Go to Solution.
06-05-2017 07:50 AM
Make sure it is not configured as a backup interface. Make sure it has an IP address and mask. All requests will follow static route table so expect only local requests to go out local interface without static routes (or default) configured.
06-05-2017 07:50 AM
Make sure it is not configured as a backup interface. Make sure it has an IP address and mask. All requests will follow static route table so expect only local requests to go out local interface without static routes (or default) configured.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide