ISE - Printer

[CSCO10662744_2]

Reading through some guides & other threads, is it correct to say two of the most prominent ways to profile printers are SNMP & NMAP probes?

I was following the HowToGuide-30 on profiling, where it instructs how to perform a NMAP probe, but when I go to our ISE nodes under Admin / System/ Deployment, I don't see any button to do NMAP.

What am I missing here?

Is NMAP manual scan still supported in ISE 2.1?

[nspasov · Accepted solution]

Hi there! Manual scan in ISE 2.1 is located under:

Work Centers > Profiler > Manual Scans

I hope this helps!

Thank you for rating helpful posts!