- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-13-2024 12:15 AM
Hello Experts,
I'm encounter error in MDS switch after do configuration for TACACS+.
MDS switch unable to run show command and get into privilege mode. Error return below
Error: AAA authorization failed for command:show running-config, AAA_AUTHOR_STATUS_METHOD=17(0x11)
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-13-2024 02:57 AM
The issue might be related to wrong or missing aaa authorization commands on the switch or something wrong on the AAA server.
Please take a look at this link where it shows the basic configs for TACACS on Cisco devices:
ISE TACACS Configuration - AllThingsNetworking
If you got everything right in terms of configs, then you might be hitting this bug:
Cisco Bug: CSCto08660 - Config fails with "AAA authorization failed AAA_AUTHOR_STATUS_METHOD=17"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-13-2024 12:20 AM
Can I see SW config
Aaa and vty line
MHM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-13-2024 02:57 AM
The issue might be related to wrong or missing aaa authorization commands on the switch or something wrong on the AAA server.
Please take a look at this link where it shows the basic configs for TACACS on Cisco devices:
ISE TACACS Configuration - AllThingsNetworking
If you got everything right in terms of configs, then you might be hitting this bug:
Cisco Bug: CSCto08660 - Config fails with "AAA authorization failed AAA_AUTHOR_STATUS_METHOD=17"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-29-2024 07:22 AM
There are miss configuration in the command line. Now everything were running fine
