Multiple access codes (passcode) in AUP portal for Sponsorcode
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-10-2025 05:05 AM - edited 02-10-2025 05:23 AM
We are implementing our new WLAN guest network with the help of Cisco ISE (3.4). We have created a portal with a sponsorcode (AUP access code). Within our PoC we filled in the passcode and that worked fine.
But new we have the request to have multiple passcode (a choose per location). Is this possible?
- Labels:
-
Identity Services Engine (ISE)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-10-2025 06:07 AM
Yes you can do that by creating different portals and configure each one in a separate authorization profile and then you associate the authorization profiles to the authorization rules where you also define the network devices location as a condition. That way based on from where the traffic will be coming from the redirection will go to the portal that has been defined in the authorization profile tied to that authorization rule.
