- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-31-2020 06:24 AM
Is there any type of documentation available that describes the detailed steps required to implement a NAC solution using ISE 2.4?
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-31-2020 07:14 AM
The prescriptive deployment guide for wired is a great place to start start.
https://community.cisco.com/t5/security-documents/ise-secure-wired-access-prescriptive-deployment-guide/ta-p/3641515
There are a list of guides the BU has put together at this page. Wireless has it's own guide too, but it tends to be a bit easier than wired.
https://community.cisco.com/t5/security-documents/ise-community-resources/ta-p/3621621
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-31-2020 07:14 AM
The prescriptive deployment guide for wired is a great place to start start.
https://community.cisco.com/t5/security-documents/ise-secure-wired-access-prescriptive-deployment-guide/ta-p/3641515
There are a list of guides the BU has put together at this page. Wireless has it's own guide too, but it tends to be a bit easier than wired.
https://community.cisco.com/t5/security-documents/ise-community-resources/ta-p/3621621
