This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.
I'm running ACS v 5.1 and have noticed that it an autheication fails the log doesn't show the username it there is a failure with the authentication, but if the autheication is successful the username shows up. Does anyone know how to make it so the failure messages are of value because it shows the username?
Here is an example:
Authentication Summary | ||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Hi can you post the entire error message, at time the eap session times out before the handshake is complete, once the handshake completes then the users credentials are sent through the tunnel where authentication occurs.
Thanks,
Tarik