Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
417
Views
0
Helpful
2
Replies

pcGrid in 2 node deployment

michaellperrin
Level 1
Level 1

‎05-20-2016 06:30 AM - edited ‎03-10-2019 11:47 PM

In a 2 node deployment should both nodes be active for pxGrid?

Only one of my nodes the pxGrid service is running while the other is disabled.

When I rebooted the node that it was running the services started running on the other.

As far as I can tell they should run active active. 

Labels:
0 Helpful
2 Replies 2

nspasov
Cisco Employee
Cisco Employee

‎05-22-2016 11:46 PM

Yes, you should run it on two nodes if you want to have redundancy. Although, it is recommended that pxGrid is run on dedicated nodes. 

Thank you for rating helpful posts!

Thank you for rating helpful posts!
0 Helpful

michaellperrin
Level 1
Level 1
In response to nspasov

‎05-24-2016 10:16 AM

Hey Neno,

Thanks for the response.  I know I should run it on two nodes.  My question is I have it enabled on both nodes, but it seems to only be running on one and not the other, and when I rebooted the one it was running on it flipped active on the other.

Should they not run active active? Or will only one node be active while the other is standby?

0 Helpful
Customers Also Viewed These Support Documents