Per-user NAT IP address assignment
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-11-2004 06:02 AM - edited 03-10-2019 07:52 AM
Hello all,
I need to perform a per-user NAT translation and can't figure out if this can be accomplished with PIX and ACS :
When an authenticated user gets access to my inside network, I need to perform NAT to assign each one an specified IP address, maybe storing the address in each user or group profile in ACS.
This is because of requirements of a web application inside the firewall, which performs authentication based on IP -no way to change this app.
Any suggestions, on whether this can be accomplished or definitely not, would be very appreciated.
Thanks a lot.
A. Arias.
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-17-2004 07:56 AM
Well according to this document you can authenticate per VPN may be your case could also be possible,
