08-10-2021 10:49 AM
As per the document to configure SNMP traps, port 161 should be open in ISE.
When checked with show ports | in 161, there were no output for the admin node.
How to open this 161 port for SNMP configuration?
Solved! Go to Solution.
08-10-2021 04:31 PM
Hi @prathapss ,
please try the following:
ise/admin# sh ports | include 161
ise/admin# show udi
SPID: ISE-VM-K9
VPID: V01
Serial: <ISE Serial Number>
ise/admin# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
ise/admin(config)# snmp-server engineid <ISE Serial Number>
% Warning: As a result of engineID change, all SNMP users will need to be recreated.
ise/admin(config)# end
ise/admin# show ports | include 161
udp: 0.0.0.0:161
Hope this helps !!!
08-10-2021 11:18 AM
Hello,
If you mean ISE send SNMP-traps, then from cli execute "snmp-server enable" the port will be open.
Hope that helps.
08-10-2021 11:25 AM
Hi,
The "snmp-server enable" configuration is already there.
Still the port is not opened.
08-10-2021 11:50 AM
Hello,
What version of ISE you have ?
Did you try to use NMAP to test if that port closed ? (even if it's not shown)
Just tested it on ISE 2.7 P4
use
no snmp-server enable
snmp-server enable
and do sh logg sys ade/ADE.log | last 30 what does log show ?
08-10-2021 04:31 PM
Hi @prathapss ,
please try the following:
ise/admin# sh ports | include 161
ise/admin# show udi
SPID: ISE-VM-K9
VPID: V01
Serial: <ISE Serial Number>
ise/admin# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
ise/admin(config)# snmp-server engineid <ISE Serial Number>
% Warning: As a result of engineID change, all SNMP users will need to be recreated.
ise/admin(config)# end
ise/admin# show ports | include 161
udp: 0.0.0.0:161
Hope this helps !!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide