Problem with Guest User Identity

[ranjit123]

Hello All,

I have the below question

Guest user accounts are created in AD and guest users authentication and authorization policies are created on ISE. Now when this Guest users browse through any internet site they are taken to the firewall and granted access as per policy.

Our requirement is to have user identity captured in firewall logs, now only logs are captured with IP address.

Its a checkpoint R80 firewall with user identity enabled..

how can i achieve this, any settings in ISE or i need to check the same on checkpoint?

Regards

[Mohammed al Baqari · Accepted solution]

You need to integrate ISE with Checkpoint through pxgrid.

Start from here

https://www.cisco.com/c/dam/en/us/products/collateral/security/identity-services-engine/at-a-glance-c45-736265.pdf

[ranjit123]

Thanks a lot... for your swift and crisp response