Radius profiling and Tacacs Device Admin on same switch

[DAVID]

What is a basic switch template that would show TACACS device administration and authentication but also allow for RADIUS profiling based 802.1x for devices connected to switch ports

[Damien Miller]

So two different components here. TACACS configuration and RADIUS/dot1x configuration, and both are too involved for a post.

Hari put together a good guide for RADIUS
https://community.cisco.com/t5/security-documents/ise-secure-wired-access-prescriptive-deployment-guide/ta-p/3641515

Krishnan also did a guide specific to TACACS
https://community.cisco.com/t5/security-documents/cisco-ise-device-administration-prescriptive-deployment-guide/ta-p/3738365