Radius-Server Failure

[hellspire69_2]

Can anyone help me with the command that acts as a failsafe for dot1x.

If the both radius servers go down, what is the command to automatically authorize everyone into there native vlan?

Kind Regards

Dan

[Jatin Katyal]

Hi Dan,

when radius server is not available and you want to allow everyone to the network for that we need to configure IAB on the switch:

Configuring 802.1X with Inaccessible Authentication Bypass:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/40sg/configuration/guide/dot1x.html#wp1203805

Please ensure that you DO configure,

# RADIUS test username
# Radius idle-time
# Radius deadtime, and
# Radius dead-criteria.

For IAB to work properly.

The configuration details can be found from,

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/40sg/configuration/guide/dot1x.html#wp1143560

HTH

Regards,

JK

Plz rate helpful posts-