Setting privileges in Cisco Secure ACS Version 5.1.0.44

[jagadisht]

I am setting privileges in Cisco Secure ACS Version 5.1.0.44.

In the command sets from the ACS server, I denied few commands as can be seen in the attached screenshot and selected 'Permit any command that is not in the table below'.

I am unable to see some commands like "Show running-configuration" from the router I was testing. What changes should I do to see all the commands other than the denied commands. Your help will be rated. Thank you.

[Erick Delgado]

Hi,

The ACS is able to handle permit or deny commands.

I created a configuration example that will help you to understand command shell.(see attach doc)

Instead of using show running-config please use show config.

also make sure that all the users are using privilege 15.

Regards,