cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

616
Views
0
Helpful
2
Replies
Highlighted
Beginner

Setting up Radius for APN authentication using ACS v5.5

Good Day All,

I am fearly new with regards to ACS as a whole, so I am not too familiar with regards to setting up a radius I basically have little knowledge..

I have been tasked to set up a RADIUS to accomodate authentications for an APN.

I just need to know what information would I need to know from my client e.g Vendor ID, Attributes, IP's.

And how would I go about creating a RADIUS specifically accomodating APN.

I have read a number of articles regarding setting up a radius but I have not picked up on anything that is specifically for setting up for APN authentication.

Please advise if more information is required.

Your Response will be highly appreciated.

Regards,

Sanele

2 REPLIES 2
Highlighted
Beginner

I would appreciate some help guys, please!!!

Highlighted

This should work

Cisco-AVPair = "gprs:apn="

Content for Community-Ad