Show running config
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2007 06:03 AM - edited 03-10-2019 03:11 PM
Hi.
I've logged the router provided by the ISP of mine (of course, with the a userid provided). I noticed that i can perform a "show running config", showing however only a partial configuration of the router (ACL, AAA, services running arent shown), a "show ip route" but i can't do anything else. I can't perform a "show privilege" or a telnet.
I figure this configuration is done via a RADIUS server (cant imagine a ISP using local authentication!), but my question is however this: how i can allow a user logging to the router to see only a part of the whole running configuration (suppose that the user has been already provided with a user being authenticated locally). This can be done only with radius?
Thank you
CZ
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2007 06:41 AM
CZ,
This can be done locally.
http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml
Regards,
Jagdeep
