SNMP

[markoep]

Hi everyone,

I'm trying to get some information via SNMP in SCADA from Cisco C2960.

When I try to get 68 informations (OID-s) everything works fine, but when I insert 69 or more, 

communication goes ˝bad˝ and I can't get any information.

Is there some kind of default setting in Cisco that allows only 68 informations to collect via SNMP(and if it is, how can I solve it),

or is it another problem?

Thanks in advance,

Best regards

[howon]

Hello, is this question for ISE? If so where are you trying to populate the OID within ISE?