tacacs+ access issue with ASA firewall after integrating with RSA SecureID

[siddhesh.rane]

Hi,

In my earlier post,  I raised the same question but let me rephrased it again. I have configured TACACS+ in cisco ASA firewall and able to access . But when I integrated it with RSA secure ID , I am not able to enter in enable mode. It is not accepting enable password nor RSA passcode. I have created enable_15 in ASA , ACS and RSA server but no luck.

Did any one face similar issue with ASA access ?

Rgds

Siddhesh

[siddhesh.rane]

Hi,

My cisco ACS is V5.4

Rgds

Siddhesh

[Jatin Katyal]

Hi Siddesh,

In order to help you here, I need to know few things:

1.] Show run | in aaa

2.] When you enter enable password on ASA CLI, what error do you see on ACS > Monitoring and reports > AAA protocols > tacacs authentication > "look for the error message"

3.] Turn on the debugs on ASA "debug tacacs" and "debug aaa authentication" before you duplicate the problem.

~BR
Jatin Katyal

**Do rate helpful posts**