11-26-2012 11:03 AM - edited 03-10-2019 07:49 PM
I am working on an ISE demo with version 1.1.2 and vWLC 7.3.101.0 code and am configuring wireless CWA. I get the following error message: Cannot enable MAC filtering and other Layer2 Security with RADIUS NAC.
Does anyone know if wireless CWA is supported on the Virtual WLC platform? I know it is supported on the 25/55xx controllers as of 7.2 code.
Solved! Go to Solution.
11-26-2012 01:12 PM
Is your Layer 2 security set to "none" and the mac filtering box checked? You are not using psk or anything else correct?
Thanks,
Tarik Admani
*Please rate helpful posts*
11-26-2012 01:03 PM
Jeff,
You can not combine mac filtering with dot1x on the SSID. You will have to use 2 seperate SSIDs, one with mac filtering and the other with dot1x.
Also you will need to open a tac case since the vlan assignment is not working on the published code releases, i ran into this a few weeks back and the bug id is - CSCua58554
Thanks,
Tarik Admani
*Please rate helpful posts*
11-26-2012 01:09 PM
My primary issue is with the error message: Cannot enable MAC filtering and other Layer2 Security with RADIUS NAC.
This has nothing to do with 802.1X and is supported on the 5508 7.2 code. This is how you configure Wireless MAB/CWA on the WLC for instance.
11-26-2012 01:12 PM
Is your Layer 2 security set to "none" and the mac filtering box checked? You are not using psk or anything else correct?
Thanks,
Tarik Admani
*Please rate helpful posts*
11-26-2012 01:22 PM
Yes, I had WPA2 enabled and overlooked it. I also didn't read the error message and your original suggestion close enough.
Thanks for pointing that out, I'm sure I would have seen it eventually.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide