cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

731
Views
0
Helpful
1
Replies
Highlighted

Wired 802.1X authentication and Vlan Assignment(Cisco ISE & SWITCH)

Hi,
We are planing to implement Wired dot1X in our network.
How can we start with the implementation  & any best practices.  Also switch end recommend configurations.
Any suggestion/ help!!
Thank you.....Laxmi!!
1 REPLY 1
Highlighted
VIP Advisor

Hi 

Hi 

The minding to deploy dot1x smoothly with less impact is following a 3 step deployment: Monitor, low impact and close mode.

This allows you to create rules and validate that users are authenticated well. If, for some reasons, users aren't able to authenticate they won't be impacted in monitor mode and few impacted in low impact mode. When everything is configured will then you can move forward with close mode. 

I can share some configuration but it won't help if you don't get how it works. 

I would suggest to read the 2 links below and you should be able to begin your config. Then if you have issues I can help. 

http://www.cisco.com/c/dam/en/us/td/docs/solutions/CVD/Aug2014/CVD-CampusDot1XDesignGuide-AUG14.pdf

http://www.networkworld.com/article/2233208/cisco-subnet/7-essential-new-features-make-deploying-wired-802-1x-easier-on-a-cisco-infrastructure.html

Thanks 

PS: Please don't forget to rate and mark as correct answer if this answered your question


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question