Solved: Re: Wireless authentication -Cisco ISE

ibrkic001 · ‎10-22-2020

Hello,

i need to setup RADIUS authentication for wireless users (secured netwok)
on Cisco ISE. Now we use ACS for that. Do i need to remove ACS from wireless controler setup, or there is a possibility to have two Radius AAA servers on controler ( ISE and ACS) in same time?

Best regards

Peter Koltl · ‎10-22-2020

y~~tgb~~

hbf

You can have multiple RADIUS servers defined on the WLC but you must choose a primary (and a secondary) server for each SSID.

View solution in original post

marce1000 · ‎10-22-2020

- As the controller only needs a radius server or servers which is a standard protocol, I presume both could be used or configured, I would however advise to migrate to a single radius authenticating platform (ISE).

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Peter Koltl · ‎10-22-2020

y~~tgb~~

hbf

You can have multiple RADIUS servers defined on the WLC but you must choose a primary (and a secondary) server for each SSID.

Aref Alsouqi · ‎10-23-2020

You would not need both ACS and ISE on your environment, ISE is the replacement for ACS, you can migrate all your ACS policies to ISE, and remove it from your network.