01-09-2017 12:55 PM
Hello
Apart from turning of the power switch, how do you correctly Shut Down / Power Off a IPS-4240-K9 from a Shell Command Line?
Thanks
Mike
Solved! Go to Solution.
01-09-2017 09:34 PM
From the sensor cli, you can issue the following command:
sensor# reset powerdown
You can also do the same from IDM or IME GUI management.
Source: step 2 in the following installation guide section:
http://www.cisco.com/c/en/us/td/docs/security/ips/interface_cards/19056_01.html#wp39058
01-09-2017 09:34 PM
From the sensor cli, you can issue the following command:
sensor# reset powerdown
You can also do the same from IDM or IME GUI management.
Source: step 2 in the following installation guide section:
http://www.cisco.com/c/en/us/td/docs/security/ips/interface_cards/19056_01.html#wp39058
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide