Hello,
i have a question about the cisco switches.
we have a rack which has:
1 san: 4x1gbit
1san: 2x1gbit
1nas: 4x1gbit
4xenservers: 6x1gbit
2x firewals2x2gbit
but the network/switching is a mass at the moment.
there are no vlans, qos or anything and i would like to configure everything correctly but the budget they gave me is €2500.
i was thinking to use 2x cisco sbs SG350X-48 in stack with lacp but i don't know if this is good enough.
is there a better setup you would recommend for this rack then those switches?
i had a look at catalyst series but then i go over the €2500 budget.
thx allot!
Mathias
