08-15-2019 02:20 AM - edited 02-21-2020 09:24 AM
Hi all,
I have a 4110 cluster which I am trying to troubleshoot a load balancing issue.
Two commands that I see frequently applied to CCL and CDL port-channels are:
! int po1 desc CDL port-channel load-balance src-dst ip-l4port port-channel span-cluster vss-load-balance ! int po48 desc CCL port-channel load-balance src-dst ip-l4port !
Between the ASA contexts, FXOS CLI/ GUI where on earth do I apply the commands? Are they even required on a firepower chassis? If not what is the load-balancing hash used, src-dst-ip?
cheers,
Seb.
08-15-2019 07:34 AM
Are you running ASA or FTD image on your Firepower appliances?
08-16-2019 12:19 AM
Hi Marvin,
It is FXOS 2.1(1.85) running just an ASA image (9.1.7(4) ).
cheers,
Seb.
08-16-2019 07:37 AM
In FXOS we only create the Etherchannel and assign ports to it. Any configuration of the resultant Etherchannel is done from the ASA cli (or ASDM).
The default configuration is src-dst-ip as noted here:
08-19-2019 12:11 AM
That is what I though and thanks for the confirmation.
However from the CLI, when in the relevant context which has been allocated a port-channel, the configuration options I am presented with are quite limited. Certainly there is port-channel load-balance .
I think I may just configure the directly connected switches to src-dst-ip to get around this issue.
cheers,
Seb.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: