802.1x access points using ISE for trigger

[jerry.larson]

                   We are deploying AP's with 802.1x ports. We do not want ot have static AP ports. When plugged into a switch port with 802.1x configured the AP does not kick up the smart port trigger. How do I link the trigger from ISE to send the response for the trigger on the swutch to reconfigure the switchport for an AP?

thanks,

[Naveen Kumar]

Hello,

Please check this link for "802.1x using Cisco ISE", it may help you in this.

https://supportforums.cisco.com/docs/DOC-29409