I need to connect from an inside host to a host located in the DMZ zone for DNS queries. The host in the DMZ zone has a static NAT to the outside. The point now is that I would like to connect from inside to the NATed outside address, means to the public Internet address.
Inside host: 10.0.0.1 -> PAT for 10.0.0.0/8 to 18.104.22.168 (Outside Interface)
DMZ host: 192.168.1.1 -> NAT to outside to 22.214.171.124
The traffic should be 10.0.0.1 udp>1024 to 126.96.36.199 udp=53. The source IP address on the outside interface now is 188.8.131.52 (according to the PAT), the destination IP address 184.108.40.206. The DNS reply from 220.127.116.11 should go back now to 18.104.22.168 and then to the inside host 10.0.0.1.
I know that on the PIX it was not possible, to have outgoing traffic on the outside interface which immediately enters again the same interface. Can I realize this scenario with the ASA 8.4(3) release now?
With the enhancements in ISE 3.0 for integrating with Azure AD via SAML IdP, it is now possible to leverage Microsoft Single Sign-On for multiple ISE Portals (for example Sponsor and Guest/BYOD Portals).
At the time of this writing, ISE cann...
With the enhancements in ISE 3.0 for integrating with Azure AD via SAML IdP, it is now possible to create a BYOD Flow to provide Wireless network access using an employee’s Azure AD credentials.
The table below shows the whole Cisco Security solutions + Splunk integrations add-ons. Kindly let me know if I have missed some add-ons or if there are any new updates. Thank you!
Hope this will be helpful for everyone who is looking for Splunk in...
A python based script to generate report if there are disabled rules under an Access Control Policy and an option to delete those rules in bulk.
Step 1 Download the script on PCStep 2 Make sure python3 is installed on PC and have reach...
A python based script to generate report if there are double logging on FMC ACP (logging at beginning and end), having rule action "Allow" or "Trust". (Option1 )
Also, the logging at the begging will be disabled if logging is detected for both beginning ...