ACL Issues
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-17-2011 04:24 PM - edited 03-11-2019 02:13 PM
Good Evening Everyone,
Got an ACL issue on my 5510. I have set up ACL's for the Inside and Outside interface. Both ACL's are identical right now as I am trying to test an issue. When I run the packet trace command in ASDM I am able to successfully pass data out the outside interface but unable to over the inside interface even though both are set exactly the same. The packet trace tool keeps pointing to a problem with the ACL which I dont understand since they are both configured exactly the same. So how come I am able to pass traffic using the outside interface but fails when using the inside interface?
Thanks
- Labels:
-
NGFW Firewalls

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-17-2011 06:38 PM
Please kindly share the configuration of the ASA, it might be issue with other configuration line.
If ACL is configured in the inbound (IN) direction, it only needs to be applied to the first interface the traffic is initiated from.
Can you please advise what traffic you are trying to pass and what is the source and destination ip address?
also pls share the output of packet tracer.
