07-16-2017 06:13 PM - edited 03-12-2019 02:42 AM
Hi,
I can show BGP in Cisco FTD from command line interface with this command: "show bgp"
How can I activate BGP and set its ASN from command line interface?
Also, when BGP is not active, I get the following correct response:
> show bgp
% BGP not active
However, after I activate BGP from the web GUI, why do I not get any information (i.e. empty response)?
> show bgp
Thanks.
07-18-2017 09:56 AM
You cannot configure FTD from CLI, you will need to use FMC (or FDM for small ASAs) UI to configure bgp.
"show bgp" displays your bgp routing table so in case you dont have any neighbors up you will see nothing.
07-18-2017 06:14 PM
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide